The electric heating boiler uses power electricity as the energy source, and heats the water through the electric heating tube to realize heating or provide domestic hot water. The boiler has high intelligence, fast heating, and high thermal efficiency. Here is the introduction of its control system.
The system is not a volumetric gas-fired atmospheric hot water boiler, so it does not need to be inspected by the local quality inspection department every year, because it is not a pressure vessel, and installation does not require approval from relevant departments. It is a reliable fast-flowing water heating equipment that can be installed outdoors and completely isolated from indoor users. It does not occupy valuable business area, is small in size, and has large energy. The gas hot water system can produce hot water 365 days a year regardless of the severe cold in midsummer, sunny or rainy weather, and has almost zero requirements on the weather. automatic control. Fully automatic continuous work, reducing the labor intensity of the staff, with functions such as instantaneous overvoltage and overcurrent protection, power device overtemperature protection, water cut-off protection, water shortage automatic water intake, and water level display. The characteristics of the condensing pressureless hot water boiler are energy saving: during the condensation of water vapor in the flue gas, it absorbs harmful gases such as NOX and SOX in the flue gas, and the harmful gas in the discharge is lower than the national emission standard. In addition, The trough solar medium and high temperature boiler can also be combined with biogas, electric power, petroleum and other thermal technologies, which is the focus of the combined application of conventional energy and new energy. Circulating fluidized bed boiler pressure fire hot start refers to stop the operation of the boiler coal feeder and all fans under unconventional circumstances, and use the large heat storage capacity of the boiler to continue to maintain the operation of the unit. If necessary, remove the furnace wall, outer casing, moisture-retaining layer, etc. for thorough inspection. If any serious damage is found, it must be repaired before continuing to use. At the same time, the inspection results and repair conditions should be filled in the boiler operation register.
